Company News

Upper roller of rolling machine in two under the roller center symmetrical positionthrough the hydraulic oil in the hydraulic cylinder piston effect on vertical lifting movement, through the last stage gear of the main reducer drive roller gear meshingrotary motion under the two cooperation, provide torque for coiled sheet. Plastic sheet metal bending machine specifications flat through the three working roller machine(two root rollers, an upper roll) between the rotary motion, by means of the upper roller and the lower roller pressure, so that the metal plate after several continuous bending, produce plastic permanent deformation, roll into the need cylinder, cone orpart of them.
 
Machine maintenance:
Maintenance of the plate bending machine is according to the requirement of eachcup of lubrication and lubrication points of artificial gas, after the power is switched on,check the motion blocking phenomenon are normal, operate strictly according to therolling machining procedure and method of operation, to be very Caution! Operation of equipment. According to the parameters of bending bending machine provisions,thickness 20mm, the maximum length of 2500mm, the rolled material yield limit is less than 250Mpa. In the operation process, if found to have irregular noise, shock and not normal phenomenon, should immediately stop check. All personnel in the operationshould be well coordinated, coil after the end, do the work finished material as the site is clean, and do a good job of equipment maintenance work, shut off the power supplyin time.